Timber creek enforcer kit
Timber creek enforcer kit, the Enforcer Ambidextrous Charging Handle is a drop-in replacement for a Mil-Spec charging handle.
To be a little different, I asked for the Enforcer kit in purple. The purple is one of the anodized colors that Timber Creek offers. I like the look of anodizing, as it has that “high gloss” look. This purple does not disappoint. The anodizing is spot on and all the different parts match. Matching anodizing, from batch to batch, is not super easy. But Timber Creek pulled it off.
Down in the FNB section, it shows what all comes with the Enforcer kit and it is a lot. I’ll go over most of the parts individually, at least the important ones. All of the parts come in one nice box. Small parts are in bags, in the buffer tube. On the back of the box is essentially a parts break down, and where those parts go. I also put together a list of what else is needed to complete a full rifle. Some of these parts can also be purchased from Timber Creek, like the barrel and castle nut, these additional parts are as follows:
-
Castle nut
-
Buffer and recoil spring
-
Trigger
-
Bolt catch
-
Mag catch
-
Upper/lower
-
Buffer retaining pin & spring
-
Barrel
-
Stock
-
Gas tube
First up I’ll start with the lower receiver small parts. The extended mag release has a nice little downward curve to it and isn’t too large. I really liked it’s function as it isn’t any higher than the standard mag release, it just sits back closer to the trigger finger. TC’s oversize trigger guard is wider also. It’s pretty oversize, so much so that I think a Sasquatch could get his finger in there. Then there are the take down pins.
UPC: 816397024303
SKU: E-AMBI-CH-R
Reviews
There are no reviews yet.